Low rise

This is really common ence but few ever think about it. A vf body does not have a removable feed neck. A low rise or no rise would be nice with a hinde due to the fact you usually wont outshoot a revy unless your using an electric trigger. So take a hack saw. Dont be scared hack saws are your friend. Cut your revy feed neckso that it is about an inch long. Then File and Sandpaper it until it fits snugly in the gun again. This should help lower your profile when playing and also make moving your gun around easier plus it looks cooler. If you sand it down too much take a sodering iron and make grooves in the plastic this will make your revy tighter fitting. i would imagine you can do this with other loaders but i wouldnt reccomend it if you are using a non agitatied one or the ricochets because they use orings to fit in the gun.


	Cokers Cockers \| home Low rise This is really common ence but few ever think about it. A vf body does not have a removable feed neck. A low rise or no rise would be nice with a hinde due to the fact you usually wont outshoot a revy unless your using an electric trigger. So take a hack saw. Dont be scared hack saws are your friend. Cut your revy feed neckso that it is about an inch long. Then File and Sandpaper it until it fits snugly in the gun again. This should help lower your profile when playing and also make moving your gun around easier plus it looks cooler. If you sand it down too much take a sodering iron and make grooves in the plastic this will make your revy tighter fitting. i would imagine you can do this with other loaders but i wouldnt reccomend it if you are using a non agitatied one or the ricochets because they use orings to fit in the gun.